How to Fix a Cracked Laptop Screen Without Replacing It

How to Fix a Cracked Laptop Screen Without Replacing It

How to Fix a Cracked Laptop Screen Without Replacing It

If you’ve broken your laptop screen, don’t immediately assume that you need to go out and buy a new one. Often, the screen can be repaired with relative ease and at minimal cost, although it will depend on what exactly broke in the first place. To learn how to fix a cracked laptop screen without replacing it, keep reading below!

Prepare the Area

You’ll need some space around your laptop so you can plug in tools and work. Because replacing an LCD screen is time-consuming, you should clear off a table or desk that has ample surface area. Remove any objects on top of it so they don’t interfere with your repair. You’ll also want to make sure you have everything you need before starting. These supplies include: phillips screwdriver, soldering iron, fine-grit sandpaper, thermal paste (optional), microfiber cloths and cotton swabs for cleaning and polishing after reassembly. You can also use zip ties for cable management.

Reinstall the LCD Screen

First, you’ll want to install your laptop’s LCD screen. Use a flashlight and your fingers to remove any gunk around or between your LCD screen and frame; once clean, snap it back into place (if necessary, take a screwdriver or knife and use small cracks in screws for leverage). Make sure that both halves of your screen are properly connected; if not, reconnect them before continuing. If you don’t know where those connections are on your specific laptop model, look online for instructions specific to your machine. Note: If you have any questions about how to fix cracked laptop screen without replacing it, consult with an expert first—sometimes it makes more sense just to get a new one!

Clean Cracks and Dust

Start by cleaning off any dust and small pieces of debris from your laptop screen. This can help eliminate some of that nasty static electricity you might get while trying to repair your screen, which is crucial when it comes time to install new glass. To clean off dust and debris, use a lint-free cloth dampened with warm water (but not sopping wet) or an electronics cleaning solution.

Prepare Heat Gun

Heat guns can be used to heat up and soften vinyl screen protectors, so they may be able to help with your cracked screen. Take a clean microfiber cloth and place it over your repair area. Do not let any foreign objects like hair, fibers or dust fall on your screen while you are doing repairs. Next, take a heat gun and cover it with a plastic protector. As heat up your laptop, move it in circles around he outside of the crack until it is no longer visibly noticeable. Once you have made an invisible repair of some sort, give your computer enough time to cool down before trying to use it again.

Heat up the Computer

Before you attempt to replace any hardware components in your laptop, it’s important that you turn off and unplug your computer from its power source. This is both for safety reasons as well as to prevent potential short circuits. If your laptop has been damaged due to some liquid exposure, be sure it’s completely dry before attempting any repairs yourself. To begin replacing parts on your laptop, follow these steps: First, remove all screws holding down your keyboard (or remove them if they’re already missing). Next, carefully pry up on each side of your keyboard until it pops off; then slide it out of its slot.

Apply Pressure to Heated Areas

Heat up your screen protector slightly with a hair dryer, then apply pressure and carefully smooth out any bubbles. This method works best on glass screen protectors. Heat from your fingertips may cause plastic ones to warp or melt. That could create more problems than it solves, so keep that in mind before you try it with plastic.

Put Back Together the Broken Parts

One of the easiest ways to fix your laptop screen is by putting back together any broken parts. Ideally, that means trying to reconnect or reattach any broken cables. That can be done by first removing any components that are attached through those cables and then looking at how they’re attached on both ends. In some cases, you may be able to realign them and then place a few drops of super glue on each one for added support. Once you have everything in place, try turning your laptop back on and see if it still works. If so, congratulations! You’ve just saved yourself hundreds of dollars by fixing your cracked laptop screen without replacing it. But if not, check out some other solutions below…

Results – Do it Yourself (DIY) or Go For Repairs?

This depends entirely on how badly your screen is cracked and whether you’re experiencing any other hardware issues with your laptop. If your laptop still works as well as it did before but now has a few cracks in its screen, then fixing it might be worth trying if you know someone who can do it for cheap. However, laptops that have major hardware problems or very bad cracks often won’t benefit from DIY repair. Hardware issues can range from annoying (crackling speakers) to expensive (random shutdowns) – either way, these usually point to deeper problems that aren’t going away on their own.

Check for Damage

The first thing you should do when your laptop’s screen cracks is check for damage. You don’t want to risk shorting out your computer or making it less responsive if there are any shards of glass in its casing. To check for internal damage, you’ll have to open up your laptop and inspect all its inner workings. Take off any screws that hold on covers or panels; then look carefully at all wires and cables. If you can find any exposed wires or chips, gently wiggle them back into place with tweezers; make sure not to apply too much pressure. If there’s nothing obviously wrong inside, try powering on your computer again—if it turns on fine, it’s safe for you to continue fixing the screen without taking anything apart.

Conclusion

comment and share
just check by using your writer;). Thank you!

Leave a Reply

Your email address will not be published.